Routers - Small Business

I can backup the router settings on an RV110W, but not restore them.  I get an "unable to write" error. (probably not the exact verbiage).  Defective router, or firmware issue?

Hello Guys, We have a Cisco 1921 as gateway and VLAN router, while my swiches are Cisco 2960 around the working site. Creating a VLAN trunk and access is not a problem within a building, without having to restart the Cisco devices. We also have offi...

Hello, I have a few of these routers in the field and I am receiving complaints where the internet is unavailable and frequently requires a router reboot to restore connection.  I have the same router in my house and have duplicated the issue and am ...

Hi guys, I need help to open port 8081 for allowing a site's web pages to access from the internal network.This site is opening from our internal network but links of this site is not opening.I have checked  this site from other network, both site a...

Hi - I'm trying to set up a network with an RV042G router to allow for VPN access to my local network.  I currently use an Actiontec FIOS router as my primary gateway/router.  I have followed most of the suggestions on this link: https://supportforu...

Hi anyone, Is RSV 4000 have capability to do failover on WAN link? Lets say I have 2 ISP (primary and backup) and I want to make SLA tracking object like on IOS router or flexlink feature. If not, is there any feature similar that?

the router does not record the bandwidth rate control settings , ex 192.168.0.1 ate'192.168.0.20 use waw 2 . Add  a new rule, is displayed the previous rule that has been deleted, it seems that is not the memory and apply new settings. the firmware ...

Hello, I have a RV325 Router. Entries in the System Log are mysterious to me and all my search results and reading are not relevant.The Event-Type is - "Kernel", and the Message is "kernel: wrong ip[0],not_list[0]"The Log entries occur every few minu...

I have just installed an RV180 router for a new customer.  The customer has Comcast Internet at 180Mbps.  With default settings, the router LAN speed tests at 180Mbps down / 12Mbps up, but with a "bufferbloat" rating of "F".   In the past (with other...

Hi All   Please go easy on me here as Mitel is not my forte... We have a remote site that connects back the main site using a gateway to gateway VPN connection,(HQ 5505) (Remote 877) this is where our Mitel 3300 is located. At the remote site we have...

Hello, I own a plenty of RV042 routers in my environment and so I want to automate some tasks like periodic configuration backup, so Telnet connection would come in handy. I've already searched about and enabled Telnet using the URL http://<Router IP...

Hi All   Please go easy on me here as Mitel is not my forte... We have a remote site that connects back the main site using a gateway to gateway VPN connection,(HQ 5505) (Remote 877) this is where our Mitel 3300 is located. At the remote site we have...

I have a RV042G which I have configure failover from WAN1 to WAN2.  When WAN1 disappears, internet access switches over to WAN2 as advertised.  However, the VPN tunnel does not.  The tunnel is configured for WAN1 with Keep Alive, Dead Peer Detection ...

Comcast requires PD support. None of my computers can access the Internet without it. I can ping using ipv6 from the router itself, but that's rather worthless.