cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1483
Views
0
Helpful
1
Replies

Cisco RV120w VPN tunnel problem

d.herremans
Level 1
Level 1

Hello,

I gave setup a vpn gateway between two cisco RV120W. The connection is established.

Active IPsec Security Association Table

Policy NameEndpointPacketsKBytesStateAction
RxTxRxTx
VPN-INTERDIO87.65.38.62000.000.00IPsec SA Established
Poll Interval:

(Seconds)

The problem is that there is no trafic. Even ping te remote internal nework is not working. For testing i have disabeld at both sites te firewall and have configured both with an access rule any to any.

Default Outbound Policy
Policy:

Allow

Block

Access Rule Table

ActionServiceStatus
Connection Type
Source IPDestination IP
Always AllowANYEnabledInbound (WAN (Internet) > LAN (Local Network))Any

1 - 1 of 1

Can anywone tel me wat i am missing in this configuration.

Wan 1: 94.224.5.118

IP internal 1: 192.9.212.1

Wan 2: 87.65.38.62

IP internal 2: 192.168.212.1

Thanks

Danny

1 Reply 1

jonatrod
Level 7
Level 7

Good morning

Thanks for using our forum

Hi Danny Herremans  my name is Johnnatan and I am part of the Small business Support community. In order to solve your problem follow these steps.

1. Go Firewall>General>Disable “Block WAN Request”

2. Go Firewall>General>Enable ”Remote Management”

3. Go VPN>VPN Pass Through>Verify all option be “enable”

4. In your  internal network  1 try using a  different address instead of  192.9.212.1 use a private network, in the range 192.168.x.x.

5. Create these two firewall rules in your computer

http://www6.nohold.net/CiscoSB/Loginr.aspx?login=1&pid=4&app=search&vw=1&articleid=2922

I hope you find this answer useful, if it was satisfactory  for you, please mark the question as Answered.

Please rate post you consider useful.

Greetings,

Johnnatan Rodriguez Miranda.

Cisco network support engineer

“Please rate useful posts so other users can benefit from it” Greetings, Johnnatan Rodriguez Miranda. Cisco Network Support Engineer.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: