11-07-2012 12:19 PM
Hello,
I gave setup a vpn gateway between two cisco RV120W. The connection is established.
Active IPsec Security Association Table
Policy Name | Endpoint | Packets | KBytes | State | Action | |||||||
Rx | Tx | Rx | Tx | |||||||||
VPN-INTERDIO | 87.65.38.62 | 0 | 0 | 0.00 | 0.00 | IPsec SA Established | ||||||
|
The problem is that there is no trafic. Even ping te remote internal nework is not working. For testing i have disabeld at both sites te firewall and have configured both with an access rule any to any.
Default Outbound Policy | ||
Policy: | Allow Block |
Action | Service | Status |
| Source IP | Destination IP | |||||||||||||
Always Allow | ANY | Enabled | Inbound (WAN (Internet) > LAN (Local Network)) | Any | ||||||||||||||
|
Can anywone tel me wat i am missing in this configuration.
Wan 1: 94.224.5.118
IP internal 1: 192.9.212.1
Wan 2: 87.65.38.62
IP internal 2: 192.168.212.1
Thanks
Danny
11-27-2012 09:02 AM
Good morning
Thanks for using our forum
Hi Danny Herremans my name is Johnnatan and I am part of the Small business Support community. In order to solve your problem follow these steps.
1. Go Firewall>General>Disable “Block WAN Request”
2. Go Firewall>General>Enable ”Remote Management”
3. Go VPN>VPN Pass Through>Verify all option be “enable”
4. In your internal network 1 try using a different address instead of 192.9.212.1 use a private network, in the range 192.168.x.x.
5. Create these two firewall rules in your computer
http://www6.nohold.net/CiscoSB/Loginr.aspx?login=1&pid=4&app=search&vw=1&articleid=2922
I hope you find this answer useful, if it was satisfactory for you, please mark the question as Answered.
Please rate post you consider useful.
Greetings,
Johnnatan Rodriguez Miranda.
Cisco network support engineer
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide