Cisco RV340 - Static routing configuration procedure

[RomanBuk1511]

Hi,

Someone can decribe me the all steps i should preform in order to excute ping between to networks.

-WAN settings

-Routing configuration

-PC NIC Configuration

The setup is: PC 1>WAN1 port, PC 2>WAN2 Port.

Thanks.

[balaji.bandi]

below guide give you basic settings :

https://notesfrommwhite.net/2015/04/23/install-and-configure-of-the-cisco-rv325-firewall/

Once you done that you can do same for other PC2 VLAN IP address.

[RomanBuk1511]

Thanks. 

But the implamentation should be via L3, i.e. static routing, WAN configuration etc, not by vlans etc.