08-07-2022 12:19 PM
Hello, I just bought a CISCO 888 router and I am trying to configure it for a very first time. The problem is that I need the L3 port for NAT but the router shows me only the L2 ports (0-3).
08-07-2022 12:26 PM
try under the L2 interface
no switch port <<- this make L2 port as L3 interface
08-07-2022 12:57 PM
Incomplete command
08-07-2022 01:05 PM
do you try config IP under the interface if you success then it L3 not L2.
08-07-2022 01:21 PM
I tried but showed me it is L2
08-07-2022 01:35 PM
can you share
show IP interface status
08-07-2022 02:03 PM
Wrong command
08-07-2022 02:12 PM
Show ip interface breif
08-07-2022 02:25 PM
08-07-2022 02:37 PM
so you dont have WAN interface you have BRI
I think you can config IP under the BRI interface
interface bri X
ip address
08-07-2022 03:06 PM
So the cable go in to SHDSL port? I will configure to receive IP from the ISP. But which BRIE to use?
08-07-2022 03:17 PM
BRI 0
08-07-2022 03:40 PM
Still not working:(
08-07-2022 03:51 PM - edited 08-07-2022 04:09 PM
https://www.cisco.com/c/en/us/support/docs/wan/point-to-point-protocol-ppp/10308-bri-mppp.html
OK, since it not accept the config then try config dialer interface and use BRI as HW interface.
check the example above
08-07-2022 12:36 PM
follow below guide :
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide