10-02-2012 08:12 AM
Hello!
Need some help with this situation.
Have one RV042 configured like ahead:
2 WAN links in Smart Link backup mode (WAN1 Primary)
WAN1 - Cable modem
WAN2 - DSL router
Network service Detection
Remote host: 8.8.8.8
Dns Lookup host: www.google.com
When i poweroff Cable Modem, NSD Fail occurs and failover works correctly.
But, when i remove only the data cable of the Cable Modem, simulanting a problem inside Cable Modem Company, failover not occurs.
Log show NSD FAIL WAN but nothing works to outside.
I've tried load balance mode in the same config above but this doesn't works too.
10-02-2012 09:00 AM
Wrong forum, post in "small business - routers". You can move your post using the actions panel on the right.
10-02-2012 09:56 AM
10-02-2012 10:43 AM
Well, i did it!
Only when i poweroff cable modem or dsl modem failover occurs naturally.
10-15-2013 07:03 AM
Hello!
Similar problem here , but with a rv320 with the latest firmware !
Best regards
Philipp
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide