09-14-2021 09:11 AM
I have RV042G with firmware v4.2.2.08 (Apr 26 2013 19:12:26). We recently had our ISP remove the 8x T1 service and install a 250MB fiber service. After the installation, when directly connected to their equipment, a speedtest is ran and 250MB speeds are accomplished. When I connected their equipment to our equipment (RV042G), we see 150MB speeds and we tested this directly off a LAN port, same cable and laptop. I have reset the RV042G to default settings, as we had lots of bandwidth configurations to try and manage the T1 service.
Is there something I need to change in our equipment (RV042G) to get the ISP provided speeds of 250MB?
Solved! Go to Solution.
09-14-2021 09:24 AM
Hold up Peoples of Cisco. I updated the firmware to the latest available and the speeds delivered by the ISP are the speeds we are getting inside our network.
Thank you for viewing.
09-14-2021 09:24 AM
Hold up Peoples of Cisco. I updated the firmware to the latest available and the speeds delivered by the ISP are the speeds we are getting inside our network.
Thank you for viewing.
09-14-2021 12:27 PM
You should get more than that as per the below test (worth updating firmware and test - if that is not the latest firmware)
09-16-2021 05:07 AM
Balaji.bandi,
Thank you for the reply and helpful website to look at my configurations. Once I updated the firmware, the speeds delivered by the ISP are the speeds I am able to achieve when looking outward to the intertubes. Internally, I am able to get much faster speeds but that was never the issue.
Thank you for your response
09-16-2021 05:55 AM
Glad all good , thank you for the feedback.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide