We have a RV082 hardware version 2. (I stated wrongly that I had v3 hardware)
The problem is really stange:
- doing a hard reset (30, 30, 30 procedure) and after loading the firmware 1.3, the WAN1 o WAN2 link LED does not turn on. In the web admin interface, both port appears disconnected. Connecting the same cable in port 1, it works.
- then, upgrading to firmware 2.0, in snmp the WAN1 does not show traffice, only the LAN Interface. And the data of the snmp is wrong (reporting million of packets/s), so there is no way to monitor activity.
My question, is the hardware malfuntioning? If so, why does it works with firmware 2.0 but report bad snmp data? Also, why does not work with firmware 1.3?
changed to v2 hardware