02-02-2013 08:09 AM - edited 03-04-2019 06:55 PM
Hello all,
From the router I can ping the 2nd router, all its host and all of the 1941w interfaces.
From the 1941w AP i cannot reach the 2nd router or any of its host, but I can reach the interface that is connected to the 2nd router but only one side of it.
Attached are both my router and ap configs. At the moment I am just trying to reach the 2nd router and its host so I can update the AP IOS image but cannot reach the tftp server.
02-02-2013 09:04 AM
Hi,
From your explanation it's hard to understand. Post here network diagram. And check your routing on both routers.
Hope it will help.
Best regards,
Abzal
02-02-2013 09:55 AM
I can ping the TFTP server from the router, but when i telnet into the AP and try i cant reach it. The farthest i cant get is 192.168.1.103 (giabitethernet 0/0)
02-02-2013 11:10 AM
Hi,
put a static route for the 192.168.2.0/24 network on the Linksys pointing towards the 1941 router.
Regards
Alain
Don't forget to rate helpful posts.
02-02-2013 11:24 AM
from the TFTP server i can ping the AP BVI 1 interface 192.168.2.2 but i still cannot ping the TFTP server from the access point. When i do a trace route for 192.168.1.1 or 192.168.148 i get nothing. If i traceroute to 192.168.1.103 i have one hop. From 192.168.2.2 to 192.168.2.1. I added the route as suggested but it did not help.
02-02-2013 05:28 PM
i figured it out. i had to enable "routing dynamic" for the ap gigabit ethernet0 interface.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: