ADSL line do not activate.
Telco Confirmed Like is Okay . They have tested no issue observed.
Router replaced but did not help.
Supspecting Firmware not compatible with telco . Not sure how to confirm on this.
sh ver
Cisco IOS Software, C180X Software (C180X-ADVIPSERVICESK9-M), Version 12.4(4)XC7, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Tue 31-Jul-07 20:24 by alnguyen
ROM: System Bootstrap, Version 12.3(8r)YH8, RELEASE SOFTWARE (fc2)
XXXXXXXXXXXXXXXXXXXXXXX uptime is 30 minutes
System returned to ROM by reload at 18:48:26 UTC Wed Oct 10 2012
System image file is "flash:c180x-advipservicesk9-mz.124-4.XC7.bin"
Cisco 1801 (MPC8500) processor (revision 0x400) with 118784K/12288K bytes of memory.
Processor board ID FCZ110220F5, with hardware revision 0000
9 FastEthernet interfaces
1 ISDN Basic Rate interface
1 ATM interface
31360K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
sh dsl interface atm0
ATM0
Alcatel 20190 chipset information
Line has not yet been activated. No information available.
DSL: Training log buffer capability is not enabled
interface ATM0
description ADSL connectionProvider France Telecom
bandwidth 320
backup delay 120 0
backup interface Dialer4
no ip address
no atm ilmi-keepalive
pvc 8/35
pppoe-client dial-pool-number 1
!
dsl operating-mode auto
end
interface Dialer1
description ADSL connection Provider France Telecom
bandwidth 128
ip address negotiated
no ip redirects
no ip unreachables
no ip proxy-arp
encapsulation ppp
dialer pool 1
dialer-group 1
no cdp enable
ppp max-configure 255
ppp chap hostname XXXXXXXXX
ppp chap password XXXXXXXXX
ppp pap refuse
end