cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
242
Views
0
Helpful
4
Replies
Highlighted
Beginner

AIM-ATM card install

   After installing the card, I configured :

controller T1 10/3/0

mode atm aim 1

framing esf

clock source internal

linecode b8z

But show controllers indicated it was down as follow.  did that mean the card is faulty? or maybe a circuit problem? Anything I was missing?

CAHSIBCDE#show controllers t1

T1 0/3/0 is down.

  Applique type is Channelized T1

  Cablelength is long gain36 0db

  Receiver has remote alarm.

  alarm-trigger is not set

  Soaking time: 3, Clearance time: 10

  AIS State:Clear  LOS State:Clear  LOF State:Clear

  Version info Firmware: 20050620, FPGA: 16, spm_count = 0

  Framing is ESF, Line Code is B8ZS, Clock Source is Internal.

  CRC Threshold is 320. Reported from firmware  is 320.

  Data in current interval (850 seconds elapsed):

     0 Line Code Violations, 0 Path Code Violations

     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 850 Unavail Secs

  Total Data (last 24 hours)

     481 Line Code Violations, 1555 Path Code Violations,

     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,

     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 86400 Unavail Secs CAHSIBCDE#show controllers t1

thanks,

alison

4 REPLIES 4
Highlighted
Rising star

first thing, why is clock source internal? change it to line.

Highlighted

thank you. I changed it line. The controllers are still down.

Highlighted
Hall of Fame Master

CAHSIBCDE#show controllers t1

T1 0/3/0 is down.

  Applique type is Channelized T1

  Cablelength is long gain36 0db

  Receiver has remote alarm.

Possible faulty circuit, or remote down.

Highlighted
Cisco Employee

Also, can you post your config that includes the "clocking" commands. More specifically, I am looking to see if your aim module is set to participate in the clocking process. The command would be like this:

network-clock-participate aim 1