Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi all.I have the following setup:Comcast "Blast!" coming in the wall @ 50MbpsMotorola SB6121 ModemCisco e3200 routerHP Pavilion dv6-6135dx with a ralink rt5390 wireless adapterThe problem is I get about 50mbps (speedtest.net) when hooked direct to m...

Hi, I have a 10Mbps connection link which I will like to reduce to 5Mbps on a 6509 switch as indicated in the config below.class-map match-all vlan313match vlan 313policy-map traffic-policy     class vlan313          shape average 5000000 20000 20000...

Hi all,I have a 1921 with 3 interfaces. One for the LAN and the other 2 are wan each with a public address. The 2 wan interfaces are used for redundancy. I would like to know how I can static nat the same port and inside address on both wan interface...

         Hi I faced a strage issue as one of our router port cable was removed  from the router port but the Port status is showing as  up /up    which made our HSRP state  to active active causing an outage , The router we are usign is cisco 3845 an...

raja d by Level 1
  • 2332 Views
  • 4 replies
  • 0 Helpful votes

Dear team,Please suggest solution for the below mentined issues.1)   KA-AGR-DEP-C1941#telnet 74.125.236.133 /source-interface gigabitEthernet 0/1% telnet connections not permitted from this terminal How can we enable telnet for the above for testing2...

Hi I have 1 Cisco VXR NPE-G2, i was looking to buy another Cisco VXR of same model, but as per information they are now EOL/EOS.Can any one recommend me alternate option of same speficiation as of VXR NPE-G2?Cisco Data sheet dont seem to have clear c...

This is driving me crazy. IP SLA works for failing over to the secondary connection (from Cable to DSL), however the SLA can never reach 4.2.2.2 from the cable, even when it is up. I can ping the interface from the outside world and get responses, bu...

Hi,I have setup a basic PBR config to route Http and Https out of a different interface (fa0/0/0) but for some reason http traffic is still going out of the Gi0/1 interface.Is anyone able to see whats wrong?Config attached minus the crypto stuff and ...

andy_4578 by Level 1
  • 5670 Views
  • 17 replies
  • 0 Helpful votes

HiI have configured E1 to use PVDm to terminate ISDN connection but I keep on getting the above error message, can you please view my config and see if you can't spot a mistake.Layer 1 and 2 seem to be working fine but layer connection isn't working....

Unanswered Topics