cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1360
Views
0
Helpful
1
Replies
Highlighted

AS5350XM and NP108, can't configure DSP, how to?

Hi folks,

I have one AS5350XM with the following (taken from sh inventory):

* E1 8 PRI DFC

* NP108 VUFC

So far I have read from the cisco documentations, I should get configured DSP on the router with the command: "voice dsp slot/dsp slot/dsp" but whenever I try to put the command it shows error like it doesn't have DSP:

--------------------------------------------

HQ-RTR(config)#voice dsp ?
% Unrecognized command
HQ-RTR(config)#voice dsp

---------------------------------------------

I just killed my whole day to get it understand why it's not giving me privilege to configure. I am using IOS: c5350-js_ivs-mz.124-24.T.bin

To get more understand i am giving some necessary command outputs:

-------------------------------------------------------------------------------------------------

HQ-RTR#sh inventory
NAME: "AS5350XM chassis", DESCR: "AS5350XM chassis"
PID: AS535XM-AC-PWR    , VID: V02, SN: XXXX

NAME: "SPE_1", DESCR: "NP108 VUFC, "
PID:                   , VID:    , SN: XXXX

NAME: "SPE_2", DESCR: "NP108 VUFC, "
PID:                   , VID:    , SN: XXXX

NAME: "E1_3", DESCR: "E1 8 PRI DFC, HwVer#: 4.8"
PID:                   , VID:    , SN: XXXX

HQ-RTR#sh voice dsp detailed

DSP  DSP                DSPWARE CURR  BOOT                         PAK     TX/RX
TYPE NUM CH CODEC       VERSION STATE STATE   RST AI VOICEPORT TS ABORT  PACK COUNT
==== === == ======== ========== ===== ======= === == ========= == ===== ============

HQ-RTR#

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------

I need your help if I am missing something to configure anything, I am just stuck at this point on my CCIE study.

Everyone's tags (3)
1 REPLY 1
Highlighted
Hall of Fame Master

Re: AS5350XM and NP108, can't configure DSP, how to?

Hello Bilashece,

see

http://www.cisco.com/en/US/docs/routers/access/as5350/software/configuration/guide/54bas2.html#wpxref24219

the command you would like to apply may be not available on this specific platform that is an access server.

Hope to help

Giuseppe