Hi folks,
I have one AS5350XM with the following (taken from sh inventory):
* E1 8 PRI DFC
* NP108 VUFC
So far I have read from the cisco documentations, I should get configured DSP on the router with the command: "voice dsp slot/dsp slot/dsp" but whenever I try to put the command it shows error like it doesn't have DSP:
--------------------------------------------
HQ-RTR(config)#voice dsp ?
% Unrecognized command
HQ-RTR(config)#voice dsp
---------------------------------------------
I just killed my whole day to get it understand why it's not giving me privilege to configure. I am using IOS: c5350-js_ivs-mz.124-24.T.bin
To get more understand i am giving some necessary command outputs:
-------------------------------------------------------------------------------------------------
HQ-RTR#sh inventory
NAME: "AS5350XM chassis", DESCR: "AS5350XM chassis"
PID: AS535XM-AC-PWR , VID: V02, SN: XXXX
NAME: "SPE_1", DESCR: "NP108 VUFC, "
PID: , VID: , SN: XXXX
NAME: "SPE_2", DESCR: "NP108 VUFC, "
PID: , VID: , SN: XXXX
NAME: "E1_3", DESCR: "E1 8 PRI DFC, HwVer#: 4.8"
PID: , VID: , SN: XXXX
HQ-RTR#sh voice dsp detailed
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT
==== === == ======== ========== ===== ======= === == ========= == ===== ============
HQ-RTR#
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------
I need your help if I am missing something to configure anything, I am just stuck at this point on my CCIE study.
