Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,We are proposing Cisco CUCM for one of my client whose business type is financial organization, so they need beep tone on each incoming/outgoing calls as a legal compliance. They must need the call recording tone to be audible & get recorded ...
Hi Experts,After configuring 'Call-Forward All xxxxxx' whereas 'xxxxxx' is a mobile number.Calls from internal ip phones to forwarded mobile number (outgoing through FXO lines) goes fine through FXO ports, after ending the call releases fine and gets...
Hi, anybody worked on Cisco QM or CR(Compliance Recording)? I have a confusion on it. There are three types of recording systems - 'Desktop Recording', 'Server Recording' and 'Network Recording', the installation and configuration guide I have found ...
Hi All,Very new idea but it's very important for me! Can I configure one particular DN and associated configurations anyhow on ICM so that those calls wont be updated on ICM database? particularly on TCD table?? One toll-free IVR service is killing m...
I hope your DSL Modem can do the PPPoE job and provide DHCP IP on its LAN. Use a small switch, as known as 'WAN Switch' or 'Perimeter Switch' and terminate your DSL Modem there. Many DSL Modem have built-in switchports on its LAN. Connect both MX 'IN...
Did you check from 'Security Appliance > Addressing & VLANs' if you have below configs:- route created from MX64 (Meraki Spoke) towards ASA/FG (non-Meraki Spoke). It should be dest: 172.16.0.1/16, gw: MX100 IP from 192.168.0.1 subnet- if the route is...
No, MX doesn't provides report like this. MS switches gives you visibility like that.However, if you notice the 'Network-wide > Clients' page, you might find few relevant information. Usually I make my mind before I connect any switch on MX and add a...
