09-20-2022 03:45 AM
Hi all, recently got my hands on an ASA 5550 and I was trying to configure it as a device on my homelab network in which it would be behind a Pre-Existing NAT with a DHCP server enabled. I configured the Firewall in transparent mode but can't pass traffic from an outside interface to an inside interface, which connects to a switch distributing the connection to the rest of my homelab devices. How should I do this?
Regards, Tyler
09-20-2022 07:29 AM
can you share config again I couldnot see it
09-20-2022 08:05 AM
simple setup that works as expected : still issue post the config and version of ASA running.
09-20-2022 08:08 AM
09-20-2022 08:36 AM
Sure post the config also post show firewall output.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide