09-14-2018 09:12 AM - edited 03-05-2019 10:55 AM
Hello Everyone!
I have a question here,
Do I need to restart the router after a license activation???
Can´t find any information on the Hardware-Installation document
Thanks!
Solved! Go to Solution.
09-14-2018 02:11 PM
Sorry, my bad.
To activate the port licenses, all you have to do is unshut 'no shut' the interface the license is for...
09-14-2018 02:01 PM
Hello,
yes, you typically need to reload the router after activating the license.
When you do a:
show license
it should give you a line similar to the one below:
Next reload license Level: ipservices
So in this example, ipservices will run after the reload.
09-14-2018 02:04 PM
Thank you Georg,
But even if it's just for a 2x1GB port license??,
I aggree with you when you upgrade from ipbase to ipservices or advservices, but from ports also?
Regards
09-14-2018 02:11 PM
Sorry, my bad.
To activate the port licenses, all you have to do is unshut 'no shut' the interface the license is for...
09-14-2018 02:13 PM
Great,
Thank you very much!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: