cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1126
Views
0
Helpful
0
Replies

BFD Flap on Sub-Interface

Hi,

This is my config

**** Interface config ****

interface GigabitEthernet0/0
description ISP Link
dampening
mtu 1540
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
no ip mroute-cache
carrier-delay msec 0
duplex full
speed 1000
media-type rj45
service-policy output SHAPE-MPLS-OUT
hold-queue 1024 in

*** Normal non-BFD Sub-interce ****

interface GigabitEthernet0/0.94
description data
encapsulation dot1Q 94
ip vrf forwarding data
ip address XXXXXX
ip mtu 1500
ip ospf message-digest-key 1 md5 7 100F071D44371F2B02546E3B22
ip ospf network point-to-point
ip ospf cost 400
ip ospf mtu-ignore
end

**** Bfd enable interface ****

interface GigabitEthernet0/0.11
description MPLS
encapsulation dot1Q 11
ip address XXXXXXX
no ip redirects
no ip proxy-arp
ip ospf authentication message-digest
ip ospf message-digest-key 1 md5 7 002D1D02557B263623121C5D191F
ip ospf network point-to-point
ip ospf cost 200
ip ospf bfd
mpls ldp igp sync delay 10
mpls ip
bfd interval 300 min_rx 300 multiplier 3
no cdp enable
end

We are only getting bfd flaps/ospf neighbour down  on GigabitEthernet0/0.11

We have checked with ISP & as per them everything is fine

We have also done BER test on the link & no error.

IOS : c3845-advipservicesk9-mz.124-15.T16.bin

Pls suggest

Br/Subhojit

0 Replies 0
Review Cisco Networking products for a $25 gift card