ā07-26-2006 01:32 AM - edited ā03-03-2019 01:27 PM
I have an eBGP peer that will not be established till a reset the peer about 10 times. I turned on ths BGP debug switch and I found that a message said:
connection collision
NOTIFICATION is sento to peer x.x.x.x
code 6 (cease).
And the BGP peer will be in Active state for long time and it will return back to Connect state and stuk in this state.
I know the problem of collision is because the both of peers are trying to initiate the connection at the same time and collision will happen.
So I want o know how to solve this problem or how to configure the peer to play only passive or active role.
ā07-26-2006 01:54 AM
Hi,
Use the following command to configure one side as passive:
neighbor
Hope that helps - pls do rate the post if it does.
Paresh
ā07-26-2006 04:30 AM
I do not think this is collision related. It rather looks like a bug that I have come across a while ago. What version of code are you running on the IOS side?
Also, the cease code comes with a sub code. Can you please let us know what the subcode is.
Thanks,
ā04-11-2018 09:59 AM
Hi Harold, What is the Bug ID, I'm seeing the same thing sporadically on a couple of my routers and I want to see if they are affected. I'm running Code version is 16.3.1a
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide