Dear all,
I encountered an issue about the BGP inbound and outbound routing issue. I have 2 routers connect to a same AS. RT1 is primary router and RT2 is secondary router. When I check on the router's interface that connecting to the WAN, RT1's interface is generating counter in output, whereas RT2's interface is generating counter in input.
I have set a metric and weight in my routers, but it still show the inbound in RT2 and outbound in RT1.
Below is my configuration. Appreciate for help.
RT1#
router bgp 88088
bgp log-neighbor-changes
network 172.2.61.0
network 10.16.15.0
timers bgp 15 20
redistribute connected
redistribute static
neighbor 172.2.61.61 remote-as 4477
neighbor 172.2.61.61 transport path-mtu-discovery
neighbor 172.2.61.61 weight 100
neighbor 172.2.61.61 route-map SET-ROUTE-LOCAL-PREF in
neighbor 172.2.61.61 route-map ADVERTISE-BGP-WAN out
neighbor 10.16.15.253 remote-as 88088
neighbor 10.16.15.253 transport path-mtu-discovery
neighbor 10.16.15.253 next-hop-self
route-map SET-ROUTE-LOCAL-PREF permit 10
set local-preference 500
route-map ADVERTISE-BGP-WAN permit 10
match ip address prefix-list ADVERTISE-ROUTE-WAN
ip prefix-list ADVERTISE-ROUTE-WAN seq 5 permit 10.16.15.0/24
ip prefix-list ADVERTISE-ROUTE-WAN seq 10 permit 172.2.61.60/30
RT2#
router bgp 88088
bgp log-neighbor-changes
network 172.2.61.0
network 10.16.15.0
timers bgp 15 20
redistribute connected
redistribute static
neighbor 172.2.61.65 remote-as 4477
neighbor 172.2.61.65 transport path-mtu-discovery
neighbor 172.2.61.65 route-map ADVERTISE-BGP-WAN out
neighbor 10.16.15.254 remote-as 88088
neighbor 10.16.15.254 transport path-mtu-discovery
neighbor 10.16.15.254 next-hop-self
neighbor 10.16.15.254 weight 100
route-map ADVERTISE-BGP-WAN permit 10
match ip address prefix-list ADVERTISE-ROUTE-WAN
ip prefix-list ADVERTISE-ROUTE-WAN seq 5 permit 10.16.15.0/24
ip prefix-list ADVERTISE-ROUTE-WAN seq 10 permit 172.2.61.60/30
