06-02-2013 11:17 PM - edited 03-04-2019 08:05 PM
Does anyone know if we setup back-2-back BRI using 2x WIC-1B-S/T-V3 ?
Using 2901 router.
Solved! Go to Solution.
08-20-2013 03:16 AM
Using the WIC-1B-S/T-V3 Interface alone you wont be able to simulate the back to back.
Reason: WIC-1B-S/T-V3 does not emulate as network.
e.g. : isdn layer1-emulate network Command wont work.
You will have to use an NT/TE Interface to simulate a ISP Side. This interface can support voice calls. Not data calls.
Below is the minimum commands required for the ISDN link to come up.
NT/TE Interface:
interface BRI0/1/0
no ip address
isdn switch-type basic-net3
isdn protocol-emulate network
isdn layer1-emulate network
isdn skipsend-idverify
end
S/T Interface:
interface BRI0/2/0
no ip address
isdn switch-type basic-net3
end
Hope this helps.
--
Regards
07-30-2013 07:29 AM
Anyone..?
07-30-2013 08:01 AM
Likely not, but you can check if you can configure the isnd network side commands.
08-20-2013 03:16 AM
Using the WIC-1B-S/T-V3 Interface alone you wont be able to simulate the back to back.
Reason: WIC-1B-S/T-V3 does not emulate as network.
e.g. : isdn layer1-emulate network Command wont work.
You will have to use an NT/TE Interface to simulate a ISP Side. This interface can support voice calls. Not data calls.
Below is the minimum commands required for the ISDN link to come up.
NT/TE Interface:
interface BRI0/1/0
no ip address
isdn switch-type basic-net3
isdn protocol-emulate network
isdn layer1-emulate network
isdn skipsend-idverify
end
S/T Interface:
interface BRI0/2/0
no ip address
isdn switch-type basic-net3
end
Hope this helps.
--
Regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: