12-21-2012 03:29 AM - edited 03-04-2019 06:28 PM
When I try to configure a voice port (like voice-port 0/0/0:15) after doing a conf t, it gives me an error of invalid input detected. What could be wrong?
We are using a Cisco 3945. Please let me know if you need any show run/show ver outputs. We have succesfully setup 3825 and 2851 in the past.
Thanks
Anupam
12-21-2012 03:42 AM
Check controller E1 configuration.
12-21-2012 03:46 AM
Hi,
As far I know you must configure digital interfacesbefore they will operate correctly, because the router does not know the type of network you will be using. The type of network to which you are connecting dictates the command you use to configure your VWIC card: ds0-group for T1/E1 CAS connections or pri-group for T1/E1 CCS connections.
http://www.ciscopress.com/articles/article.asp?p=664150
Hope it will help.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide