Changing MAC address on a physical interace

[loiccruchade]

Hello everyone,

I need to change the MAC address on a physical interface of my switch.

The command is not aviable in the interface configuration mode.

The switch is model is : 

Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 28 WS-C3650-24TS 03.03.04SE cat3k_caa-universalk9 INSTALL

Is it because this modèle does not support this feature ?

Thanks for the help

[paul driver]

Hello

you can configure a static MAC address mapping to the interface 

macaddress static xxxx xxxx interface xxx

res

paul

[loiccruchade]

Hi Paul,

Thanks for your help.

Correct me if i'm wrong, but this command is for creating a static entry in the mac address table.

So it says "to join this mac address, go through this interface" right ?

I need the switch to use a specific mac address on this interface because our ISP use mac filtering.

Every traffic not in the specific mac address range is dropped.

[paul driver]

Hello
Apologies mis-understood the question

Okay I am assuming this port is a Switchport not a routed port?

What switch type is it?

Res
Paul

[loiccruchade]

I t's a WS-C3650-24TS :

Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 28 WS-C3650-24TS 03.03.04SE cat3k_caa-universalk9 INSTALL

[loiccruchade]

As far as I understand, it's a switchport.

I can't create sub-interface.

[meisemann7]

I'm trying to do something similar, did you ever get an answer to your question?

[Daniel90]

I am using a virtual switch, but you can add the mac address directly to the interface:

And here is the output from it's neighbor 

Hope that helps!!