07-04-2014 08:11 AM - edited 03-04-2019 11:17 PM
my Troubleshooting:
s1:rommon>confreg
s2:
do you wish to change the configuration? y/n [n]: y
enable "diagnostic mode"? y/n [n]:
enable "use net in IP bcast address"? y/n [n]:
disable "load rom after netboot fails"? y/n [n]:
enable "use all zero broadcast"? y/n [n]:
enable "break/abort has effect"? y/n [n]:
enable "ignore system config info"? y/n [n]:
change console baud rate? y/n [n]:
change the boot characteristics? y/n [n]: y
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2-15 = boot system
[0]: 2
S3:ROMMON> Reset
No progress
S4:ROMMON>DIR FLASH:
c2800nmc-spservicesk9-mz.150-1.M7.bin
s5: boot flash:c2800nmc-.bispservicesk9-mz.150-1.M7.bin
No progress
but,found.
Readonly ROMMON initialized
AUTOBOOT entry: NVRAM VALUES: bootconf: 0x2, autobootstate: 0
autobootcount: 0, autobootsptr: 0x0
Autoboot state 0 BOOT variable returns: cptr = 0x0
autoboot about to execute command buffer: "boot flash:"
cptr = 0x0
program load complete, entry point: 0x8000f000, size: 0xcb80
program load complete, entry point: 0x8000f000, size: 0xcb80
loadprog: error - Invalid image for platform
e_machine = 213, cpu_type = 135
boot: cannot load "flash:"
autoboot: returned from boot command
AUTOBOOT exit: NVRAM VALUES: bootconf: 0x2, autobootstate: 2
autobootcount: 0, autobootsptr: 0x0
autoboot: issue do_reset()
SOS !!!!!!!!!!!!!
Thank you very much.
07-04-2014 08:17 AM
Supplement:
flash--------format
07-05-2014 07:53 AM
I would suggest to boot from network (tftp) with IP_BASE image.
After you will be able to troubleshoot your flash (if it's the cause).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: