cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1039
Views
0
Helpful
4
Replies

Cisco router management over VPN

Piotr Kowalczyk
Level 1
Level 1

Hi,

I’m trying to manage Cisco router (using internal interface) but not able to get access (even ping) -VPN is working ok. In ASA it was quite simple, just to use command: management-access inside but how to do this in router?

Thank you for advise

4 Replies 4

Edison Ortiz
Hall of Fame
Hall of Fame

No configuration is required.

Verify the internal interface configuration for ACL preventing access and/or IP subnet configuration.

Thank you for your reply.

I believe ACL doesn't prevent access as I can ping any host inside the network but not internal IP address of the Cisco router.

Could you post config please?

HTH,
Dragan

HTH,
Dragan

So you are trying to access the internal IP address via the VPN or via an internal host?

If so, it could be an issue of allowing that communication via the VPN.

Check the VPN ACL and make sure this flow matches.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco