01-09-2007 08:40 AM - edited 03-03-2019 03:18 PM
It has been a while since I have used it. But thier was an IOS cmd where you could send a note to any users in the router. Does anyone know the command. I thought that it was cisco# speak and then the note but that doesn't seem to be working for me. Any help I will rate.
01-09-2007 08:53 AM
Hi,
what platform are you using? do you mean a banner motd?
config t
(config)#banner motd # Use strictly prohibited #
Regards
Peter
01-09-2007 08:54 AM
Josh
You got the first letter right. Check out "send" instead of "speak". Send is used to send messages to other users on the router.
HTH
Rick
01-09-2007 08:55 AM
The command is "send"
HTH
01-09-2007 09:00 AM
Is it "send" which u r looking for???
Router#send ?
* All tty lines
<0-81> Send a message to a specific line
aux Auxiliary line
console Primary terminal line
qdm Send a message to QDM client
tty Terminal controller
vty Virtual terminal
Router#send *
Enter message, end with CTRL/Z; abort with CTRL/C:
hello ^Z
Send message? [confirm]
Router#
***
***
*** Message from tty0 to all terminals:
***
hello
Router#
If this is not what you are looking for , can you tell me what you meant by any users in the router??????
Thanks,
Pallavi
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: