Command for disabling usb module on ISR 4k

[daud.2.khan]

Hi All,

In the ISR G2 series we have the "hw-module usb disable" command to disable the usb module however I am unable to find the equivalent command on ISR 4K series ( 4221 and 4321).

Could you please assist in the same.

Any other info, do give me a shout.

[Julio E. Moisa]

Hi

Please let me verify that. You are right is not supported for 4000 serie:

Supported Platforms

The USB Disable feature is supported only on the following Cisco ISR Generation 2 (G2) platforms:

•Cisco 1941 ISR

•Cisco 2901 ISR

•Cisco 2911 ISR

•Cisco 2921 ISR

•Cisco 2951 ISR

•Cisco 3925 ISR

•Cisco 3925E ISR with Services Performance Engine (SPE) 250

•Cisco 3945 ISR

•Cisco 3945E ISR with SPE 250

[daud.2.khan]

Hello, thanks for the response.

However, don't you think if it had been the same command, I would've taken the toil to raise a new case in the support community ?

P.S. - Its not the same command.,

[Julio E. Moisa]

Yes, that is correct, please let me find more information about that. 

[Brian McPhillips]

Was this information found? Having the same issue on a 4321 and 1117

[jalonj]

Hello, is there an update to this question? Many folks are having the same issue, I believe.

[hi]

Hi, did you find the command to disable or enable usb on isr 4k?