Configurar acesso SSH em switch c2960x

[helder-ganhao]

Tenho um switch Cisco c2960x de 24 portas, mas neste momento só com acesso telnet por via CLI (Putty). Necessito que o switch tenha acesso ssh e gostaria de saber quais os comandos certos para fazer esta configuração, sem estar ligado por consola, mas sim por Putty. Na imagem segue informações do switch assim como a seguinte configuração que acho estar relacionada com o modo de telnet:
line con 0
login local
line vty 0 4
login local
transport input all
line vty 5 15
login local
transport input all

Desde já agradeço toda a ajuda.

[MHM Cisco World]

You need 

Username xxxx password xxxx

Enable password xxxx

And under vty 

Privilege level 15

Also for ssh you need 

Ip domain name xxx

crypto key generate rsa

MHM

[paul driver]

Hello @MHM Cisco World 
fyi -  Ip domain name xxx not required when you label the crypto key generation

[paul driver]

Hello
to enable ssh on the switch you need to do the following:
conf t
crypto key zeroize
crypto key generate rsa label LOCAL general-keys modulus 2048
ip ssh version 2

line vty 0 15
transport preferred none
transport input ssh
transport output ssh
end
wr mem

[helder-ganhao]

Hello paul driver thanks for your help.

Right now after do that sequence comands I not have acess by CLI with ssh or telnet. 

The access to the switch maybe only by console

[MHM Cisco World]

Use 

transport input all
transport output all

And you can access via telnet 

For ssh

And did you do what I suggest before?

MHM

[helder-ganhao]

Hello MHM right now I don't have access phisical to switch to do access by console. And can access by CLI. And yes I do your suggest. I'm really newbie in this configurations of switchs, but I'll learn.

[paul driver]

Hello

---

@helder-ganhao wrote:

Hello paul driver thanks for your help.

Right now after do that sequence comands I not have acess by CLI with ssh or telnet. 
The access to the switch maybe only by console

da.

---

Okay leave the cfg I asked yo to implement inplace for the time being.

Are you able to at least reach the switch via ssh or not, if not then you need to give the switch a mgt ip address

int vlan 1
ip address x.x.x.x y.y.y.y.y 
not shut
eixt
ip default-gateway x.x.x.x

also I did notice you had login local applied to the vty lines, which indicates you have created a local user account on the switch, have you done that?

Again if not,
conf t
username xxx privilege 15 secret xxxx
exit

Make sure the above is applied and if not perform the above steps and test access once again please.

[MHM Cisco World]

Friend never run command 

transport input ssh
transport output ssh

Before you sure SSH work good

He can not anymore access SW

So he need to access via console 

And make 

transport input all
transport output all

After that he check ssh' in this case if he failed he can access via telnet 

MHM

[paul driver]

hello
Op confirmed they had console access, hence no reason why not to apply ssh on the vty lines