09-26-2020 08:05 AM
I'm VERY much a beginner ! Is there some magic ip address to use for interface vlan ???? I want is to configure gigabitethernet0/1/0 as a port connected to an unmanaged switch for PC, printer, NAS, etc ! The addresses should be assigned by dhcp pool and default-router 172.16.1.30 !
What I've tried is random ip address for vlan 5 ----- interface gig0/1/0 will NOT accept ip address with dhcp pool ----- gig0/1/0 will accept switchport access vlan 5 and switchport mode access ! My PC does not get valid ip address ! Other than, NO experience, what am I missing?
09-26-2020 08:44 AM
- Check if this guide can help you :
M.
09-27-2020 01:47 AM
YES, I have that configuration guide ----- I reset the router to factory setting and started over again !!!! I have programmed a WAN on gig0/0/0, a dhcp pool, and a LAN on gig0/0/1. Looking at the configuration guide: page 3) step 2) I enter interface vlan 1 because it is the router default vlan and media type is already ethernet. step 3) I tried to enter ip address 172.16.1.30 255.255.255.0 -----that address is the default-router for the dhcp pool and I used it to config gig0/0/1 so it creates a conflict. I'm a beginner and find all of this VERY frustrating. Can't a dhcp pool be used on more that one router port ???? I sure hope so ---------
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide