About lam32123

lam32123 · 09-26-2020

I'm VERY much a beginner ! Is there some magic ip address to use for interface vlan ???? I want is to configure gigabitethernet0/1/0 as a port connected to an unmanaged switch for PC, printer, NAS, etc ! The addresses should be assigned by dhcp po...

lam32123 · 09-18-2020

I have configured gig 0/0/0 to connect to my ISP with ip address dhcp and ip nat outside --- my Cisco isr4331 router accepts the dynamic ip address and connects. Now --- I want to configure gig 0/0/1, gig 0/1/0 and gig 0/1/1 to automatically address...

Web User Interface for day zero routing · 09-09-2020

I have configured host name, passwords, and GigabitEthernet0 (management port) to ip address to 192.168.1.1 ! That seems to work as a basic configuration. According to chapter 5 of "Cisco 4000 Series ISR Software Configuration Guide" I tried se...

lam32123 · 09-07-2020

I enter what's shown below, yet upon router rebooting (power off/on) I'm taken to Router> prompt instead of R1 prompt ! What am I missing in saving a boot configuration to the router ? If I can't save my work, what's the point ? (host name is one ...

lam32123 · 09-27-2020

YES, I have that configuration guide ----- I reset the router to factory setting and started over again !!!! I have programmed a WAN on gig0/0/0, a dhcp pool, and a LAN on gig0/0/1. Looking at the configuration guide: page 3) step 2) I enter inte...

lam32123 · 09-25-2020

I honestly did not see the similarity of these two solutions until I had to troubleshooting my work. BOTH ip address 192.168.1.1 solution and ip address 172.16.1.30 solution work. I chose the 172.16.1.30 solution because the 192.168.1.1 ip address ...

lam32123 · 09-24-2020

Paul, thank you for your halp. I have entered:router(config)# interface gigabitethernet0/0/0router(config-if)# description WANrouter(config-if)# ip address dhcprouter(config-if)# ip nat outsiderouter(config-if)# no shutdownrouter(config-if)# exitrou...

lam32123 · 09-22-2020

ThreeBears#show runBuilding configuration...Current configuration : 1734 bytes!version 15.5service timestamps debug datetime msecservice timestamps log datetime msecno platform punt-keepalive disable-kernel-core!hostname ThreeBears!boot-start-markerb...

lam32123 · 09-21-2020

IT WORKS !!!!!The router now assigns ip address as needed to GigabitEthernet0/0/0 ----- however I do not have communication to my internet service provider. I'm presently using the following:interface gigabitethernet 0/0/0ip address dhcpip nat outsid...

Member Since	‎09-07-2020 02:25 AM
Date Last Visited	‎09-27-2020 09:27 AM
Posts	12
Total Helpful Votes Received	5

User Statistics

User Activity

configuration of NIM-ES2-4

Do I use DHCP Server or Pool Manager

Web User Interface for day zero routing

Saving router configuration

Re: configuration of NIM-ES2-4

Re: Do I use DHCP Server or Pool Manager

Re: Do I use DHCP Server or Pool Manager

Re: Do I use DHCP Server or Pool Manager

Re: Do I use DHCP Server or Pool Manager