Configuring 'no ip redirects' on a c3725 w/16 port Etherswitch NM
When configuring a c3725 for no ip redirects, the command takes on the onboard FastE ports, but not on the module FastE ports. I have attempted the command globally, on each interface individually, and as an interface range. Each time I receive "invalid input", and when I look at available commands, the no ip redirects command is not listed. Surely there must be a way to apply 'no ip redirects' to these ports? Thanks in advance.
Configuring 'no ip redirects' on a c3725 w/16 port Etherswitch N
As Jon mentioned that the ports where you are trying this command are probably L2.
The switch modules that are supported with this router are HWIC-4 or HWIC-9ESW, NM-16ESW, these modules provide L2 ports only.
There is another module NME which provides L3 ports, however, you have to get into the NME to configure those ports. I am quite +ve that you are trying the command on router, so, you aren't using this NME module which leaves you with the above L2 modules where the command "no ip redirects" isn't supported.
Cisco Digital Network Architecture Center Tools <Template Editor > In this article, we are going to talk about the Cisco Digital Network Architecture Center Template Editor tool.Cisco DNA Center gives us the flexibility and scalability to confi...
Community Live- Cisco SD-WAN Policies: Leveraging the Full Power of Cisco SD-WAN
(Live event - formerly known as Webcast- Tuesday 24 March, 2020 at 10 am Pacific/ 1 pm Eastern / 6 pm Paris)
This event had place on Tuesday 24th, March 2020 at 10hrs P...
IS there a way to upgrade the ios on a cisco 9200l switch using a usb drive instead of using a tftp server? If so could someone point me to the article or tell me how this can be done? These switches seem to be more complicated than previous switches. Tha...
Hello,I'm needing to integrate the Cisco Firepower 2110 into our Data Center JUST to fulfill Site-to-Site and Remote Access VPN. My SD-WAN ISRs already have FW and IPS running, which is what I want since I have internet breakouts at my branches, so this D...
Hi, Switch 1 and switch 2 connected via trunk. Both configured with new vlan 3.When creating new vlan 3, is it need to include "Spanning-tree vlan 3 priority 8192"- Sw 1 and "Spanning-tree vlan 3 priority 16384"-Sw 2?What will happen for those s...