09-27-2012 12:02 AM - edited 03-04-2019 05:41 PM
Hi Experts,
I'm a bit confused on why, when I issue a "show route" command on my Cisco 5510 ASA the default route shows: d*
Please see below for the output.
There seem to be no small letter "d" in the codes below.
Why am I getting this kind of default route?
Result of the command: "sh route"
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
* - candidate default, U - per-user static route, o - ODR
P - periodic downloaded static route
Gateway of last resort is x.x.x. to network 0.0.0.0
C a.a.a.a 255.255.255.0 is directly connected, inside
C y.y.y.y 255.255.255.248 is directly connected, outside
d* 0.0.0.0 0.0.0.0 [1/0] via x.x.x.x, outside
Solved! Go to Solution.
09-27-2012 06:17 AM
Is it not the default route being received via DHCP on your WAN interface?
09-27-2012 06:26 AM
Hi,
I think this is a default route learned via DHCP with ip address dhcp setroute command.
Regards.
Alain
Don't forget to rate helpful posts.
09-27-2012 06:17 AM
Is it not the default route being received via DHCP on your WAN interface?
09-27-2012 06:26 AM
Hi,
I think this is a default route learned via DHCP with ip address dhcp setroute command.
Regards.
Alain
Don't forget to rate helpful posts.
09-27-2012 03:10 PM
Alain, Pompey,
Thank you for the reply. That clears my confusion.
May I know if this d* route is given priority over S*?
Regards,
Jemel
09-27-2012 07:00 PM
Hello,
i think S* has priority .
thanks
09-27-2012 10:53 PM
Hi,
I don't think so as these are both static routes with an AD of 1.
Regards.
Alain
Don't forget to rate helpful posts.
09-29-2012 01:06 AM
Hi Alain,
I also thought it would be the same because both have an AD of 1.
If so, what would be the best practice, if I have 2 routes going to the internet?
Interface1 - is learned via DHCP from ISP, the other interface2 - PPPoE from ISP?
Should I enable set-route on both interfaces?
Or should I only enable it on the active interface that's is forwarding the traffic?
Thank you.
Regards,
Jemel
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: