E1 to WIC

[rajivrajan1]

Hi ,

There is a Channelised E1 output which is from mux . as my controller port is faulty can i connect this outout of e1 ( RJ45) to 2mb modem ( RAD ASM)(using WIC in router) and get the link through ?

Actually i tried it and failed .. is there any suggestions ?

[paolo bevilacqua]

Can you describe again what is that you want to connect and where ?

[shivlu jain]

kindly check the switch setting at modem end.

regards

shivlu jain

[rahul0904]

If I understand the setup correctly, you will require a RAD convertor modem as the output that you are getting is G.703 which needs to be converted to V.35

[paolo bevilacqua]

The problem is that is not really clear what the OP wants to do.

Cisco routers have G.704/G.704 natively with the right cards and need no converters.