01-03-2013 07:29 PM - edited 03-04-2019 06:34 PM
Dear all,
If I have two E1 router directly connected each other by using G.703 unframe method for data transimission. How to configure the router? Any sample configuration?
Thanks!
01-04-2013 02:06 AM
Hello
First Time , you must add E1 controller on each router with command
router-config# card type e1 0 0
router-config# no shutdown
after doing that , the router will create a virtual serial interface, for example (s0/0/0.0)
you need to attribuete IP @address to serial s0/0/.0
config#int s0/0/0.0
config-int# ip address 192.168.1.1 255.255.255.252
you will do the same command in each router and it will work.
01-04-2013 03:45 AM
Actually, no iterface is created without configuring channel-group.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide