07-04-2013 12:27 AM - edited 03-04-2019 08:22 PM
Good morning,
I've a problem with a router 2911 (IOS 151-2.T1.bin).
On gigabitethernet 0/0 with command sh interface.... is see this line
output flow-control is XON, input flow-control is XON
On the other gigabitethernet with the same command I see
output flow-control is unsupported, input flow-control is unsupported
How it's possible to modifiy the gigabitethernet to have output flow-control is unsupported, input flow-control is unsupported?
Thanks in advance
regards
giancarlo
Solved! Go to Solution.
07-04-2013 02:01 AM
Try this one:
https://supportforums.cisco.com/thread/2027655
Michael
Please rate all helpful posts
07-04-2013 02:01 AM
Try this one:
https://supportforums.cisco.com/thread/2027655
Michael
Please rate all helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: