GRE Tunnel

[arunkumarravi]

IP add of VPC1 is 192.168.1.10 , VPCS 2 is 192.168.2.10

GRE tunnel is configured between R3 and R4.
Tunnel is up and I am able to ping the VPC2 from VPC1 and vice versa, however if I take a capture I couldn't able to see the Tunnel IP being encapsulated.

[MHM Cisco World]

capture do you use filter ?

[arunkumarravi]

No I didn't use any filter.
Other than ICMP no other traffic is generated.

[MHM Cisco World]

what software you use eve-ng or CML ?

[arunkumarravi]

I am using eve-ng

[MHM Cisco World]

https://support.cloudmylab.com/portal/en/kb/articles/wireshark-capturing-on-eve-ng-pro-24-2-2019

use wireshark to open capture traffic, check link above 

[arunkumarravi]

Problem is not the filter or wireshark, I can see the ICMP packets from wireshark but not the actual encapsulated IP.

[MHM Cisco World]

Ok, 
share the config I will check it 

what I suspect you mistake config the static route 

ip route x.x.x.x y.y.y.y <tunnel destination>    <<<-- this wrong 

you need 

ip route x.x.x.x y.y.y.y <tunnel IP>     <<<- this is right 

the static route to remote peer tunnel IP end shift the traffic to enter the tunnel.

[arunkumarravi]

Yeah that's right. may be the route issue.

let me change and check

[MHM Cisco World · Accepted solution]

you need these two command.

R3
ip route 192.168.1.0 255.255.255.0 184.50.255.193

REMOTE router 
ip rotue 192.168.2.0 255.255.255.0 184.50.255.192

note:- in mid router you dont need these static route 

S 192.168.1.0/24 [1/0] via 4.15.133.218
S 192.168.2.0/24 [1/0] via 23.50.138.134

[arunkumarravi]

Thanks , it is resolved now.

[MHM Cisco World]

you are so welcome 

[arunkumarravi]

Can you also suggest me how to achieve this with the help of BGP(Instead of static route)