Hot swap PA-MC-8TE1+

[kokencisco]

Hallo,

Can I do "hot swap" with a PA-MC-8TE1+ interface on a 7200 router?

[maher]

Yes. Just done it today on my operational routers :). No problem at all.

[kokencisco]

Good!!! But I don't know if it is the right solution. My problem is that the interface's red led "AL" is light and I don't view the interface in the "sh run" therefore I had think to eject and plug-in the interface newly!!

[maher]

For this type of card, need to enable the config.

Router#sh diag 1

Slot 1:

PA-MC-8TE1 Plus Port adapter, 8 ports

Port adapter is analyzed

Port adapter insertion time 00:02:17 ago

EEPROM contents at hardware discovery:

Hardware Revision : 2.0

PCB Serial Number : JAE073502RH

Part Number : 73-7549-02

Board Revision : A0

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Deviation Number : 0-0

Product (FRU) Number : PA-MC-8TE1+

Top Assy. Part Number : 800-19387-02

Enable either e1 or t1

Router(config)#card type e1 1

then should be okay.

[kokencisco]

THANK YOU A LOT!!! I don't know anything about this!! So, i type "sh diag 2" and the result is this:

Router# sh diag 2

Slot 2:

PA-MC-8TE1 Plus Port adapter, 8 ports

Port adapter is analyzed

Port adapter insertion time 19w1d ago

EEPROM contents at hardware discovery:

Hardware Revision : 2.0

PCB Serial Number : JAE0826MVJ9

Part Number : 73-7549-02

Board Revision : A0

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Deviation Number : 0-0

Product (FRU) Number : PA-MC-8TE1+

Top Assy. Part Number : 800-19387-02

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF 40 03 4E 41 02 00 C1 8B 4A 41 45 30 38 32

0x10: 36 4D 56 4A 39 82 49 1D 7D 02 42 41 30 03 00 81

0x20: 00 00 00 00 04 00 80 00 00 00 00 CB 94 50 41 2D

0x30: 4D 43 2D 38 54 45 31 2B 20 20 20 20 20 20 20 20

0x40: 20 C0 46 03 20 00 4B BB 02 FF FF FF FF FF FF FF

0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

but i don't know if I have to enable E1 or T1!!!

On this interface there is a PRI ISDN at 120Ohm....I cannot configure it because I never did it...can you help me?

Bye

[maher · Accepted solution]

Hi,

Not sure in your country. In my country we use E1. Yes, can configure channelized E1 like previous interface E1/PRI 1200hm PA

regards,

maher

[kokencisco]

Hi, thanks you a lot!!!!

My contry is ITALY, Do you know what's if the standard is E1 or T1 ?