cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
925
Views
0
Helpful
1
Replies
Highlighted
Beginner

How to do force-switchover on RSP720?

I found that there is no force-switchover command under redundancy configuration mode. How can I do a switchover from primary RSP720 to secondary RSP720?

I am using SSO and NSF.

C7609-2(config)#do sh redundancy

Redundant System Information :

------------------------------

       Available system uptime = 1 hour, 51 minutes

Switchovers system experienced = 0

              Standby failures = 0

        Last switchover reason = none

                 Hardware Mode = Duplex

    Configured Redundancy Mode = sso

     Operating Redundancy Mode = sso

              Maintenance Mode = Disabled

                Communications = Up

Current Processor Information :

-------------------------------

               Active Location = slot 5

        Current Software state = ACTIVE

       Uptime in current state = 1 hour, 51 minutes

                 Image Version = Cisco IOS Software, c7600rsp72043_rp Software (c7600rsp72043_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRD8, RELEASE SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2012 by Cisco Systems, Inc.

Compiled Mon 09-Apr-12 10:54 by prod_rel_team

        Configuration register = 0x2102

Peer Processor Information :

----------------------------

              Standby Location = slot 6

        Current Software state = STANDBY HOT

       Uptime in current state = 1 hour, 48 minutes

                 Image Version = Cisco IOS Software, c7600rsp72043_rp Software (c7600rsp72043_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRD8, RELEASE SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2012 by Cisco Systems, Inc.

Compiled Mon 09-Apr-12 10:54 by prod_rel_team

                          BOOT =

                   CONFIG_FILE =

                       BOOTLDR =

        Configuration register = 0x2102

Everyone's tags (2)
1 REPLY 1
Beginner

How to do force-switchover on RSP720?

sorry...I have found it... it is under privilege exec mode instead...

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards