cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1258
Views
0
Helpful
1
Replies

How to do force-switchover on RSP720?

rakyomin78
Beginner
Beginner

I found that there is no force-switchover command under redundancy configuration mode. How can I do a switchover from primary RSP720 to secondary RSP720?

I am using SSO and NSF.

C7609-2(config)#do sh redundancy

Redundant System Information :

------------------------------

       Available system uptime = 1 hour, 51 minutes

Switchovers system experienced = 0

              Standby failures = 0

        Last switchover reason = none

                 Hardware Mode = Duplex

    Configured Redundancy Mode = sso

     Operating Redundancy Mode = sso

              Maintenance Mode = Disabled

                Communications = Up

Current Processor Information :

-------------------------------

               Active Location = slot 5

        Current Software state = ACTIVE

       Uptime in current state = 1 hour, 51 minutes

                 Image Version = Cisco IOS Software, c7600rsp72043_rp Software (c7600rsp72043_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRD8, RELEASE SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2012 by Cisco Systems, Inc.

Compiled Mon 09-Apr-12 10:54 by prod_rel_team

        Configuration register = 0x2102

Peer Processor Information :

----------------------------

              Standby Location = slot 6

        Current Software state = STANDBY HOT

       Uptime in current state = 1 hour, 48 minutes

                 Image Version = Cisco IOS Software, c7600rsp72043_rp Software (c7600rsp72043_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRD8, RELEASE SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2012 by Cisco Systems, Inc.

Compiled Mon 09-Apr-12 10:54 by prod_rel_team

                          BOOT =

                   CONFIG_FILE =

                       BOOTLDR =

        Configuration register = 0x2102

1 Reply 1

rakyomin78
Beginner
Beginner

sorry...I have found it... it is under privilege exec mode instead...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers