HWIC-DSLSAR with Alcatel module not working on Cisco 2821 Router

[mrtech_lko]

Hi! All,

I've configured HWIC-DSLSAR with alcatel module on cisco 2821 router. After configuration the card which has the interface ATM 0/0/0 shows initializing and protocol down. The IP towards ISP's side is DHCP and therefore it is configured as negotiated. Can Some One Help me in getting this card work on 2821.

The help would be highly appreciated.

thanks

Attached is output of various commands needed to check the configuration part.

Please Help.

[mrtech_lko]

Sir,

Replaced the HWIC-ADSLI with HWIC-ADSL but it is not connecting to isp. what can be the problem.

I am onsite, please advice

Thanks

[paolo bevilacqua]

Send output of show dsl interface.

[mrtech_lko]

Dear sir,

Thanks a lot for your advices.

Now the ADSL module is up and the connection is working fine.

Thanks a lot for your kind cooperation.

Warm Regards

KPS Padam

[paolo bevilacqua · Accepted solution]

You're welcome, please remember to rate posts using the scrollbox below,