Routing

Hi all,I upgraded the firmware of my rfswitch to v3.92 but the enable password has changed and i'm unable to get in to the box in enable mode anymore. Does anyone know what the password may have changed to? Would it be corrupted at this point?Anyone...

HI,I am using Cisco 1841 Router. From Cisco datasheet i found that it forwards at the rate 75000 PPS (Packet per Second).If i have 1000 Users in the LAN, how to calculate whether this router is capable of handling the Load without overwhelming the CP...

I have 2 Internet connections over my 1841 router , 1 is terminated over the serial link and the other one over the ethernet link where as the 2nd ethernet port is for internal network. I want to implemet policy based routing so when ever some one tr...

All,We have 6 T1s that are bundled in MLP. I noticed that we have CRCs on ALL of the serial interfaces, and I'm not sure why. Below is the result of "sh int | inc CRC". 14 input errors, 14 CRC, 10 frame, 6 overrun, 0 ignored, 7 abort 10 input...

We have a c7206XVR with a npe 400 and a c7609 with sup720. These routers are connected with an OC3 circuit which suppose to has a maximum throughput of 155Mb/s. The 7206 is using a PA-POS-1OC3 and the 7609 is using a PA-POS-2OC3. But for some reas...

HiCan you please confirm how many BVI interafce i can configure on my cisco 2851 router.Scenario is cisco 2851 is connected with the firewall with 2 number of L2 switches with 2 Gig interafce on 2851 are connected to 2 diffrent L2 switches.we are not...

Hello,Please can you help me tune the following buffers :Large buffers, 5024 bytes (total 6, permanent 0, peak 12 @ 2w6d): 6 in free list (5 min, 50 max allowed) 3062 hits, 5251 misses, 2893 trims, 2899 created 5094 failures (0 no memory)...

Dear sir,Iam having cisco 2821 router and i have 8 mbps bandwidth on that now i have in that router vwic2 2mfte1 cord through this card i wat divert the bandwidth 4 MB one place and 2mb one more place.Is possible.plz give me ur suggessions.srini

Hey guys,A stack of 3750 switches all reloaded with the message: "System returned to ROM by power-on"The probelm is nothing else in the room or power board lost power! Is there any bug that can cause switches to crash, but display the power on messag...

I have been using a Cisco 837 for a while now and upgraded to an 877 on the weekend. One of my requirements is that I need to be able to connect to our work network via a IPSEC VPN tunnel using the Microsoft Windows VPN client.On the Cisco 837 this w...