cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1170
Views
0
Helpful
8
Replies

HWIC not showing after upgrading IOS

Arshad Khan
Beginner
Beginner

HI,

I have Cisco 2801 router with IP Base image, i have upgraded its image into advance Ip services for using IP SLA features but after upgradation HWIC card not showing in configuration.

When i recall IP base image then configuration show presence of HWIC card but with advance IP services HWIC card not showing.

Kindly advice.

BR,

Arshad Ahmed

2 Accepted Solutions

Accepted Solutions

Leo Laohoo
Hall of Fame
Hall of Fame

What is the HWIC card (exact part number)?

What is the exact IOS (post the "sh version" if you're not sure)?

View solution in original post

Right-o.  You need a minimum of 12.4(20)T (IP Base feature set) to get to work.

1- and 2-Port Fast Ethernet High-Speed WIC for Cisco Integrated Services Routers

View solution in original post

8 Replies 8

Jeff Van Houten
Contributor
Contributor

You need to research the hardware supported for the specific version of ios and the specific hardware you are using.

Sent from Cisco Technical Support iPad App

Talha Ansari
Beginner
Beginner

Hi Arshad,

Hope you have not downgraded the IOS version in the process of upgrading the featureset. Post here the current and previous image names.

Regards,

Talha

Leo Laohoo
Hall of Fame
Hall of Fame

What is the HWIC card (exact part number)?

What is the exact IOS (post the "sh version" if you're not sure)?

Dear All,

Kindly note down the IOS, ROUTER and HWIC details.

Router PID: CISCO2801 VO5

Previous IOS : c2801-ipbase-mz.124-15.T10

Current IOS :  c2801-advipservicesk9-mz.124-25a.bin

HWIC : HWIC-1FE

Regards,

Arshad Ahmed

Right-o.  You need a minimum of 12.4(20)T (IP Base feature set) to get to work.

1- and 2-Port Fast Ethernet High-Speed WIC for Cisco Integrated Services Routers

Hi Leo,

Thanks for reply.

As is need IP SLA feature so i have to implement c2801-advipservicesk9-mz.124-20.T.bin

but it require DRAM/FLASH 192/64 but memroy present in my Cisco 2801 is 128/64.

Regards,

Arshad Ahmed

Arshad Ahmed

Clearly you have conflicting requirements. The features that you want require a version of code that requires physical resources greater than what your router has. There are only a couple of alternatives and you may not like any of the alternatives:

- you can upgrade RAM and flash.

- you can choose which of the features you can get along without (have the IP SLA without the WIC or have the WIC without the IP SLA).

HTH

Rick

HTH

Rick

Dear all,

Thanks for your helpfull reply.

I have order for DRAM and FLASH in this regards.

Regards,

Arshad Ahmed

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: