Interface Dialer Bandwidth with ATM Interface

[infomil]

Hi,

I would like to know how to automatically have correct bandwidth under my Dialer Interface who is attached to an ATM Interface.

Command bandwidth inherit doesn't work.

=>

interface ATM0

no ip address

no ip route-cache cef

no ip route-cache

no atm ilmi-keepalive

dsl operating-mode itu-dmt

pvc 8/35

encapsulation aal5mux ppp dialer

dialer pool-member 1

!

end

interface Dialer1

bandwidth inherit

ip address negotiated

sh int atm 0

ATM0 is up, line protocol is up

Hardware is DSLSAR (with Alcatel ADSL Module)

MTU 4470 bytes, sub MTU 4470, BW 928 Kbit, DLY 2200 usec,

sh int di 1

Dialer1 is up, line protocol is up (spoofing)

Hardware is Unknown

MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec,

Bandwidth under dialer is still 56Kbit and under ATM 0 928 Kbit !!!

Thanks

[paolo bevilacqua]

Check virtual-access interfaces.

[infomil]

Yes, interface virtual access 2 got the right bandwidth.

But I have CBWFQ applied under dialer 1 interface so I need to have the right bandwidth for this interface for CBWFQ !

[paolo bevilacqua]

Since VA inherits all configuration from dialer, everything will work as supposed.

Please remember to rate useful posts with the scrollbox below.

[infomil]

Sorry but VA inherit everything but queueing strategy, I've got Dialer 1 with Class-based queueing and VA2 with fifo queueing ?

At least, my question is : is there a command to have bandwidth under dialer1 automatically equal to atm bandwidth ???

[paolo bevilacqua]

That could happen because the default PVC traffic category (UBR) does not allow QoS.

Beside that, it is working as designed, nothing will ever change any configuration under dialer.