02-13-2008 10:53 PM - edited 03-03-2019 08:42 PM
How to configure intervaln routing on 4507 switch.suppose in the network 2,3,4,5 vlans are exist.
02-14-2008 12:32 AM
Hi
Since the switch is a layer 3,just create an svi for each vlan,and give one ip corresponding to each vlans subnet.
Eg:vlan 10 - 10.10.10.0/24
vlan 20 - 10.10.20.0//24
interface vlan 10
ip address 10.10.10.1 255.255.255.0
interface vlan 20
ip address 10.10.20.1 255.255.255.0
arun
02-14-2008 01:46 PM
to go along with this each port on the switch when you assign the VLAN make sure you use the correct IP as the default gateway for the host/server connected. The DG is the IP assigned to the VLAN.
02-14-2008 01:47 PM
you will also need to make sure IP Routing is enabled.
from CLI
in conf t mode
ip routing
This places the switch into layer 3 mode.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide