Hi All,
This should be real simple, but for some reason it does not work. My 6500 is only allowing me to enable one VLAN interface at a time.
!
interface Vlan2165
ip address 10.201.BB.30 255.255.255.224
shutdown
!
interface Vlan3038
ip address 10.201.BB.138 255.255.255.224
!
interface Vlan3065
description CTX-ROUTER
ip address 10.201.BB.161 255.255.255.240
no ip redirects
ip flow ingress
shutdown
====================
As you can see only interface vlan 3038 is not shutdown. When I try to do the "no shut" command on the other interfaces, nothing happens and the interface still shows administratively down. Is there some special command I need to make sure is in place on the 6500 to make sure that I can have more than one VLAN interface enabled at once??
====================
6513(config)#do sh int vlan3065
Vlan3065 is administratively down, line protocol is down
Hardware is EtherSVI, address is 000d.662f.4b80 (bia 000d.662f.4b80)
Description: CTX-ROUTER
Internet address is 10.201.26.161/28
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not supported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 packets output, 0 bytes, 0 underruns
0 output errors, 3 interface resets
0 output buffer failures, 0 output buffers swapped out
