06-03-2013 04:57 AM - edited 03-04-2019 08:05 PM
I was trying to apply route-map in Cisco 3560 Switch (C3560-IPBASEK9-M), Version 12.2 (55)SE5, I am able to create route-map but I am not able to apply it on any interface, Kindly reccomend any solution
06-03-2013 06:04 AM
Hello
Depending on if that IOS supports PBR then make sure you are not trying to apply it to a switchport, as PBR require a routed port to work.
int x/x
no switchport
ip policy route-map xxx
res
Paul
Please don't forget to rate any posts that have been helpful.
Thanks.
06-03-2013 06:42 AM
Hi,
My requirement is
I have a Cisco 877 router which is configured for internet and I have connected this router in the fa0/23 port of Cisco 3560 switch.
interface FastEthernet0/23
description ******Connected ADSL RTR*****
switchport access vlan 333
switchport mode access
spanning-tree portfast
interface Vlan333
ip address 172.16.15.1 255.255.255.0
no ip redirects
no ip unreachables
no ip proxy-arp
I need to route the traffic to this router from the 3560 Switch only for a 172.16.15.0/24 subnet so need to set the next hop ip address as the ip address of the router. I have created a route-map and when i try to apply it using the command
ip policy route-map
Do i need to change the IOS version??
06-03-2013 06:50 AM
Hi,
for Policy Based Routing, you need an IP Services Image and need to change the SDM Template:
Hope that helps
Rolf
06-03-2013 06:53 AM
Hello Krishna,
It is not supported in IP BASE for this platform. However, it is supported in IP SERVICES feature set.
Hope this helps,
Jose.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide