ISDN configuration confused

[d_unafraid]

Hi All

I am having some difficult time trying to setup my ISDN line for internet access. I have two ISDN line going to a single router, my configuration is as of below, what am i missing?

I am understood from the ISP that SPID configuration is not required as well as the name and password. I read up from some book that mention a command line that say "dialer-map ip", what is this? and if this is necessary to get the configuration working?

interface BRI0

ip address negotiated

encapsulation ppp

dialer idle-timeout 30

dialer string 62714212

dialer load-threshold 1 either

dialer-group 1

isdn switch-type basic-net3

ppp multilink

!

interface BRI1

ip address negotiated

encapsulation ppp

dialer idle-timeout 30

dialer string 62741675

dialer load-threshold 1 either

dialer-group 1

isdn switch-type basic-net3

ppp multilink

!

interface FastEthernet0

ip address 203.92.x.x.x.255.248

speed auto

!

ip classless

IP cef

ip route 0.0.0.0 0.0.0.0 BRI0

Ip route 0.0.0.0 0.0.0.0 BRI1

ip route 203.92.x.x.x.255.248 203.92.74.234

no ip http server

!

dialer-list 1 protocol ip permit

!

line con 0

line aux 0

line vty 0 4

password xxxx

login

Thank you for your time!

[mahmoodmkl]

HI

Looking at u r config i think u r missing the authentication part and username password commands.

Thanks

Mahmood

[d_unafraid]

Hi there

R u sure about that? cause i have check with Service provider a number of time and they keep saying i dont need that. please advice thank!

[d_unafraid]

BTW i discover that when i send a trace route from to a public server in the Internet, I realised the route keep looping on the fastethernet0 interface

[ahpark78]

You will need to have authentication in-placed as to authenticate that you are the right party. Your ISP should have the routers and you should use the hostname of their routers as username.

Either:

a) it can be dial-up from the ISP,you will use dialer-map.

b) both way authentications.

c) any others that I dun know?

If not, everybody will be able to dial-up the ISDN numbers and use it.

Please rate the post if helpful.

thanks,

ken L.

[nbhandarkar]

The ppp authentication chap is missing from Bri0 and Bri1 interface.

Your query regarding the traceroute output looping to your fa interface, u will need to check/inspect the routing table.