ISR 4331 + SM-X-ES3-16-P - Exit?

[GTC Hubgrade]

Hello,

i've a ISR 4331 with a SM-X-ES3-16-P module, when i'm accessing trough console to the ISR then i access to the module, i don't find a way to exit the module and return to the router console, i've tried ctrl+shift+6+^x plus disconnect, ctrl+^c, commands exit, end but the connection remains, i only return to the console router session when i reload the physical equipment, anyone knows a way to exit the module?

[Michael Deku]

A post in this discussion has been removed due to possible misconduct. Please refer to the CSC terms of use for more details.

[dscrimpsher]

When you open a session with the SM-X-ES3-16-P module you should have seen the notice (below) about how to exit the session. You need to enter CTRL+a CTRL+q to exit the session.

Establishing session connect to subslot 1/0
To exit, type ^a^q

picocom v1.4

port is        : /dev/ttyDASH0
flowcontrol    : none
baudrate is    : 9600
parity is      : none
databits are   : 8
escape is      : C-a
noinit is      : no
noreset is     : no
nolock is      : yes
send_cmd is    : ascii_xfr -s -v -l10
receive_cmd is : rz -vv

Terminal ready

SM-X-ES3-16-P

[mamanske4]

Thanks for the tip. I was trying to type ^a^q instead of using the Ctrl keys.