Hello everybody, I have one problem and any advice would be great:
This is my situation:
Telecom operater have access lines for people who dial into my company to get to Internet. My company have 2 WIC-2T interfaces which are connected to telco. Something close as this:
TELCO Equipm. for dial in -----------link for traffic distribution--------------WIC2T(CISCO 2651XM)----Internet
note: there are two ports combined in multilink (4Mbps speed)
PROBLEM: When an user use only one B channel of an ISDN connection, Telco equipment connect user to my router and user is able to connect to Internet by us.
When user combine 2 B channels into multilink, there is no traffic at all from the user to the my company or Internet. I don't know what could be problem
This is the brief config of my Cisco 2651XM
aaa new-model
!
!
aaa authentication login default local
aaa authentication ppp default group radius
aaa authorization network default group radius
aaa accounting delay-start
aaa accounting network default start-stop group radius
!
aaa session-id common
clock timezone CET 1
no network-clock-participate slot 1
no network-clock-participate wic 0
ip cef
!
vpdn enable
!
vpdn-group 1
accept-dialin
protocol l2tp
virtual-template 1
terminate-from hostname cvxtunel
source-ip <!!!!!!!!REMOVED!!!!!!!>
l2tp tunnel password 0 <!!!!!!!!REMOVED!!!!!!!>
!
vpdn-group 2
accept-dialin
protocol l2tp
virtual-template 1
terminate-from hostname tunelcvx
source-ip <!!!!!!REMOVED!!!!!!!!>
l2tp tunnel password 0 <!!!!!!!!REMOVED!!!!!!!>
!
!
!
username <!!!!!!!!REMOVED!!!!!!!> privilege 15 password 0 <!!!!!!!!REMOVED!!!!!!!>
username <!!!!!!!!REMOVED!!!!!!!> password 0 <!!!!!!!!REMOVED!!!!!!!>
!
!
interface Multilink1
ip address <!!!!!!!!REMOVED!!!!!!!> 255.255.255.252
ppp multilink
ppp multilink group 1
!
interface FastEthernet0/0
ip address <!!!!!!!!REMOVED!!!!!!!> 255.255.255.248
duplex auto
speed auto
!
interface Serial0/0
no ip address
shutdown
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial0/1
no ip address
shutdown
!
interface Serial0/2
bandwidth 2048
no ip address
encapsulation ppp
no fair-queue
ppp multilink
ppp multilink group 1
!
interface Serial0/3
bandwidth 2048
no ip address
encapsulation ppp
no fair-queue
ppp multilink
ppp multilink group 1
!
interface Virtual-Template1
ip unnumbered FastEthernet0/0
no logging event link-status
peer default ip address pool default
no keepalive
ppp authentication pap chap
ppp ipcp dns <!!!!!!!!REMOVED!!!!!!!> <!!!!!!!!REMOVED!!!!!!!>
ppp multilink
!
ip local pool default <!!!!!!!!REMOVED!!!!!!!>
ip route <!!!!!!!!REMOVED!!!!!!!>
ip route <!!!!!!!!REMOVED!!!!!!!>
ip route <!!!!!!!!REMOVED!!!!!!!>
ip route <!!!!!!!!REMOVED!!!!!!!>
ip route <!!!!!!!!REMOVED!!!!!!!>
ip route <!!!!!!!!REMOVED!!!!!!!>
ip route <!!!!!!!!REMOVED!!!!!!!>
!
!
no ip http server
no ip http secure-server
!
snmp-server community <!!!!!!!!REMOVED!!!!!!!>
snmp-server contact <!!!!!!!!REMOVED!!!!!!!>
!
!
radius-server attribute 8 include-in-access-req
radius-server host <!!!!!!!!REMOVED!!!!!!!> auth-port 1812 acct-port 1813 key <!!!!!!!!REMOVED!!!!!!!>
radius-server retransmit 0
!
control-plane
!
!
!
