Multiple Vlan to switch port

[feruqhshariff]

I Have cisco catalyst 2960-S switch with fortinet 30E as a gateway.

have default vlan 1 and one new vlan 22

I want to add few ports to both the vlan 1 and 22 so that i can connect the wifi access points to that port and access both vlan's via wifi.

[feruqhshariff]

Please someone help me to achieve this

[Kasun Bandara · Accepted solution]

what is the access point model you are using. as you request we can configure port as trunk mode and allow vlan 1 and 22 for that. but some access points (controlled via capwap tunnels)  needs only access mode port and management network assigned to that.

[feruqhshariff]

i would be using Unifi Access Points.

what is the command to configure as trunk mode and allow vlan1 and 22

[Thomas Schmitt]

1. If you are using AP with CAPWAP, then configure that port as access port in WLAN management VLAN.
2. If you have a local brackeout (Flex connect / autonomous (FAT) AP), then configure a trank port with allowed VLANs 1 and 22; trank native WLAN Management VLAN

[MHM Cisco World]

Yes @Kasun Bandara correct it depend on AP you use is it Local or Central Switching.